Do you want to avoid the expense of getting your new home theater system or your new loudspeakers set up by a specialist? An installer will typically charge at least several hundred dollars for a simple setup. There are quite a few problems that are regularly made. I am going to give various pointers to help make your set up a snap. After unpacking your new home theater system, you will normally find a main component and 5 or seven loudspeakers. The central component is going to provide the audio for every one of your loudspeakers which you are going to set up. This main element is the main hub of your home theater system. You will typically be able to control it by remote control. It will process the sound and separate it into the sound component for every separate speaker. Choose a location for the surround receiver. You may wish to place it where you have the largest amount of space. Nonetheless, please also keep in mind that you are going to need to run loudspeaker cable to each speaker, so do not choose a place that is too distant. Pick a place that is not far away from your audio source or TV since you will need to connect the receiver to your source. The receiver requires an audio signal in order to deliver surround sound. Generally it is going to accept an optical surround sound signal. You can connect this input to your television set by using a fiberoptical cable. This cable may not be included with your system however it is available at every electronics shop. However, setting up your loudspeakers can be somewhat more difficult .
If you have wireless rear loudspeakers you will not need as much loudspeaker cable and the setup is going to be somewhat easier. First of all, measure how much speaker cord you are going to require. You may want to add some extra length for safety. In many cases, you will not be able to run the cable in a straight line to your speakers. You may need to think about carpets, furniture and so on. As a result make certain you include all of these additional bends in your calculation. Loudspeaker cord is available in different gauges. The more wattage you are driving into your loudspeaker the bigger the required gauge. This is going to prevent your cord from overheating and also helps minimize cable losses. Your woofer will usually have a built-in amplifier and attach to your receiver via RCA cable. The satellite loudspeakers each attach via a loudspeaker terminal which is normally color coded to help ensure correct polarity. Pick a loudspeaker cord which shows one strand in a different color than the other. Then attach the cord to all speakers the same way. Similarly, every speaker output of your surround receiver is color coded. When attaching the cable to your receiver, watch the right polarity once more. This is going to keep all of your speakers in phase.
If you are using wireless loudspeakers (come across more info regarding tv wireless speakers at http://www.ifinity-speakers.com), there will be a small audio delay incurred throughout the audio transmission to the loudspeakers, also called latency. The amount of latency is dependent on the cordless system. It is usually less than 25 ms. For optimum sound, all of the loudspeakers should be in sync. If you have a kit which utilizes cordless rears and wired front speakers, i.e. you have a mix of wireless and wired loudspeakers, you should try to delay the audio going to the wired speakers by the latency of the wireless speakers. Verify with the manufacturer if your surround receiver can be set to delay the signal of particular channels. If you are using cordless rears, you want to set the front-speaker and side-speaker channels to delay the audio. Normally home theater systems that were designed for cordless speakers or have a wireless transmitter are going to have this capability and allow your loudspeakers to be in phase.
Leave a Reply